• photos/foto_1.jpg

  • photos/foto_2.jpg

  • photos/foto_3.jpg

  • photos/foto_4.jpg

  • photos/foto_5.jpg

  • photos/foto_6.jpg

  • photos/foto_7.jpg

  • photos/foto_8.jpg

  • photos/foto_9.jpg

  • photos/foto_10.jpg

  • photos/foto_11.jpg

  • photos/foto_12.jpg

  • photos/foto_13.jpg

  • photos/foto_14.jpg

  • photos/foto_15.jpg

  • photos/foto_16.jpg

  • photos/foto_17.jpg

  • photos/foto_18.jpg

  • photos/foto_19.jpg

  • photos/foto_20.jpg

  • photos/foto_21.jpg

  • photos/foto_22.jpg

DINB100-SA is a simple one-door standalone biometric system (or two doors if combined with the DINRTT). The programming is fast and easy. The reader can store up to 100 finger templates (97 users and 3 administrators). It has one relay output and one exit button input. If secure installation is needed, the reader can be connected to a remote relay unit in the secured area (RTT or DINRTT), which also plays the role of an exit push button. In addition to this, this remote electronic can manage a second relay allowing connection to a second door, an alarm system, light, etc. The complete setup and programming can be done only by scrolling and tapping on the sensor.

Mounting Flush mount
Housing No (ABS cover frame)
Colour Silver, Red, Green, Dark Grey, Blue, White
Fingerprint Capacity 97 + 3 templates
Output 1 x Relay (2A, 24V AC/DC) - 2 relays combined with DIN-RTT
Push Button Input Yes
Door Open Time Pulse (1 to 60sec) or Toggle(ON/OFF)
Entry Mode Finger (Basic installation)
Finger or/and card (when used with card reader DINMTPX)
Finger or/and PIN code (when used with keypad DINPAD-M)
Finger on Card (when used with mifare reader DINMTPX-MF)


By scrolling and tapping on the sensor or by keypad (when used with keypad DINPAD-M)

Backlight ON/OFF Yes
Buzzer ON/OFF Yes
Power Supply 9-14V DC
Current Consumption 100 mA
Indication Tricolor Status LED and 4 x Programming LEDs
IP Factor IP40 (indoor use only)
Operating Temperature -20C to +50C
Dimensions (mm) 80 x 80 x 9